Peak Air Conditioning Glen Waverley provides evaporative cooler service Glen Waverley wide for ducted roof-mounted units, including Breezair, Braemar, Coolair and Bonaire coolers. A pre-season service checks the cooling pads, the water pump, the float valve, the distribution lines, the salt bleed valve and the fan, then tests the airflow at each ceiling outlet before the first hot day. When a cooler is blowing warm air, leaking through the ceiling or giving off a musty smell from the vents, the technician finds the cause on the roof and explains it in plain terms. Older and discontinued models are inspected as well, with the parts question answered before any money is spent. Bookings run from 6am to 10pm, seven days. Call to book a service or a repair and receive a fixed written quote before any part is replaced.
GET A FREE QUOTE
Air conditioning work in Glen Waverley draws on three licensed trades: refrigerant handling, electrical connection and, for gas heating, gasfitting. Peak Air Conditioning Glen Waverley is based in the suburb, so a job off Kingsway, in a Legend Park Estate house or in a new townhouse near the station is a local trip rather than a drive across Melbourne. Two things decide whether a new or repaired system performs: who handles the work, and how the system is sized for the rooms it serves.
Peak Air Conditioning Glen Waverley
A ducted evaporative cooler sits on the roof, draws outside air through water-soaked pads and pushes the cooled air down through ducts to outlets in each room's ceiling. The service covers the whole system: the roof unit, the duct connections, the ceiling outlets and the wall controller. Whatever the make, every ducted evaporative cooler is built around the same core parts: pads, a water pump, a float valve, a tank, a bleed or drain valve and a fan. That shared design is why the service applies across brands, with only the model-specific parts changing. The brand on the roof changes the parts, not the checklist.
Breezair coolers are made by Seeley International, and Braemar and Coolair appear in the same manufacturer's list of residential brands. Breezair's own product page describes its Chillcel pads and an advanced water management and distribution system. A Breezair or Braemar service follows the model's own maintenance steps, including the pad type, the pump and the drain arrangement that particular unit uses, so the work matches how the cooler was designed to run.
Coolair and Bonaire coolers are serviced to the same pattern: pads, pump, float valve, tank and fan. Older and discontinued models raise a different question, which is whether original parts are still available or a compatible part will fit safely. The technician checks the model plate, confirms what can be sourced and says plainly when a repair is no longer good value against a new unit.
Many Glen Waverley homes date from the 1950s to the 1970s and sit on large blocks, often around 800 square metres, so a single cooler can feed a long run of ducts and a lot of ceiling outlets. A large cooler working hard across a big floor plan shows weak pads, a tired motor or a leaking duct joint sooner than a small one. The service checks that the far rooms receive their share of the air, not just the hallway.


Peak Air Conditioning Glen Waverley
A pre-season service is a set of checks on the roof unit and inside the house, done before the first hot spell rather than during it. Melbourne cost guides describe it as a pre-summer job that includes pad inspection and water system checks (The Quote Yard, 2026). Each step below has its own purpose.
The pads are where the cooling happens, so they are checked for scale, algae, sagging and dry patches that let warm air slip through. Pads that still wet evenly and hold their shape are cleaned and refitted. Pads that are crusted or collapsing are flagged for replacement, and the new set is matched to the cooler's model so it seats correctly in the frame.
The pump lifts water from the tank to the top of the pads, and the distribution lines spread it evenly across them. The technician runs the pump, clears any blocked line or outlet and watches every pad wet down from top to bottom. The float valve is then checked to confirm it fills the tank to the right level and shuts off cleanly, because a sticking float is a common source of overflow.
As water evaporates off the pads, the minerals it carried are left behind in the tank. The tank is drained, the sludge and debris are cleaned out and the drain valve is checked to seal properly. The salt bleed valve, which sends a small stream of water away to keep mineral levels down, is tested so it is neither blocked nor running to waste.
The fan is checked for bearing noise, wobble and dust build-up, and on older belt-driven units the belt is checked for wear and tension. With the cooler running, airflow is then felt at each ceiling outlet through the house. A weak outlet points to a loose duct, a crushed section in the roof space or a damper left closed, and that finding is noted on the service report.
Peak Air Conditioning Glen Waverley
Evaporative cooler repair is part of the same service, because most faults are found either during the pre-season check or when the cooler is first switched on for summer. Each fault shows up as one of a handful of symptoms inside the house. The symptom narrows the search, but the cause is confirmed on the roof before any part is quoted, often on the same visit as the service.
When the fan runs but the air is warm, the pads are usually not getting wet. A failed pump, a blocked distribution line, a closed water supply tap or a float valve stuck shut can all cause it. Warm, sticky air can also come from closing the house up, because an evaporative cooler needs a few windows or doors open so the humid air can escape and fresh air can keep flowing.
Water through a ceiling outlet or a stain around one points to the roof unit or the duct beneath it. Common causes are a float valve that will not shut off, an overflowing or cracked tank, a drain valve that no longer seals and a failed seal where the cooler meets its roof flashing. The leak is traced from the source, because a damp ceiling can sit some distance from the actual fault.
A musty smell usually comes from stagnant water sitting in the tank, algae on the pads or debris left from the previous season, and a tank clean with pad replacement normally clears it from the unit. A fishy or burning smell is different: it can point to an overheating electrical part, such as the motor or its wiring. In that case the cooler should be switched off at the isolator until it is inspected.
If nothing happens when the controller is switched on, the fault may be the wall controller, the wiring between the controller and the roof, the control board in the unit or the fan motor itself. The technician tests each in turn rather than replacing parts on a guess. Some faults are a seized motor bearing or a failed capacitor, while others trace back to a controller that has simply stopped communicating with the unit.


Peak Air Conditioning Glen Waverley
An evaporative cooler is out of sight on the roof, so most owners only see the result: cool air or warm air. Peak Air Conditioning Glen Waverley keeps the process clear, from the booking to the quote to the finished service report. Three points set out how the work is handled.
Once the fault is found, the technician explains what has failed and gives a fixed written quote for the repair before any part is replaced. If an older cooler needs a part that is hard to source, the quote says so, along with the option of replacing the unit instead. Nothing is fitted until the quote is approved, so the final bill matches what was agreed.
Services cover Glen Waverley on both sides of Springvale Road, from the streets around The Glen and Kingsway to the older homes near Jells Park and Dandenong Creek. Nearby City of Monash suburbs such as Mount Waverley, Wheelers Hill, Mulgrave and Notting Hill are covered too. Glen Waverley is the council seat of the City of Monash, so the whole municipality sits close at hand.
Bookings are taken from 6am to 10pm, seven days a week, which makes it easier to fit a roof visit around work and school. Pre-season services can be booked well ahead of summer, ideally in spring before the cooling season starts, and repair visits are arranged same-day where possible. Roof work depends on the weather, so a visit may be moved if it is wet or very windy, with a new time confirmed straight away.
Peak Air Conditioning Glen Waverley
Published cost guides give a useful starting range for a standard service, and the size of the cooler, the condition of the pads and the roof access then set the final figure. These figures are indicative guide prices, not the business's own rates, and a written quote is given after inspection.
The Quote Yard puts an evaporative unit serviced before summer in Melbourne, including pad inspection and water system checks, at around $180 to $320, with a Victorian range of $150 to $350 (thequoteyard.com.au, September 2026). Nationally, hipages lists an evaporative service at around $250 to $350, depending on the size of the home (January 2026). Those prices cover inspection and cleaning, not new pads.
Pad replacement is priced separately from the service, and unit size is the biggest factor. A small cooler carries fewer and smaller pad panels, while a large cooler serving a big home has more pad area across its sides, so a full set costs more. The pad type the model takes, such as Breezair's Chillcel pads, also affects the price. Published cost guides do not agree on a pad price, so no figure is given here. What the guides do agree on is the interval: pads typically need replacing every two to five seasons, depending on the water (The Quote Yard, 2026).
No published guide gives a reliable evaporative-specific figure for pump, fan motor or control board repairs, so this page gives none. The price depends on which part has failed, whether an original part is still made for that model or a compatible one is needed, and how long the diagnosis takes on the roof. The repair is quoted in writing once the failed part is confirmed.
A cooler on a single-storey roof with easy access is quicker to reach than one on a steep or two-storey roof. Many newer townhouses on subdivided Glen Waverley blocks are two storeys, and a cooler there may need extra ladders or safety equipment to reach. Access is checked at booking or on arrival, so it is built into the quote rather than added afterwards.


Peak Air Conditioning Glen Waverley
Skipping the service can look like a saving until the cooler fails on the first hot weekend of the year. The difference between the two approaches is mostly about timing, wear and what builds up inside the unit over several seasons. Each point below looks at a different side of it.
Cost guides list the evaporative service as a pre-summer job (The Quote Yard, 2026), which fits a once-a-year booking in spring before the cooling season starts. The manufacturer's owner manual sets the service interval for each model and is worth checking. A cooler that runs heavily through summer, or one fed by hard water, gains the most from being checked every year.
Coolers tend to fail when they are first asked to work hard, which is also when everyone else's cooler is being switched on. Repair bookings fill quickly in a hot spell, so a cooler that breaks down then can leave the house warm while it waits for a slot. A spring service moves that inspection to a quieter time of year, when a worn pump or a sticking float can be fixed without the pressure of the heat. Urgent faults in refrigerated systems are handled through emergency air conditioning repair.
Leaving a cooler unserviced for several seasons lets the problems compound. Mineral scale builds on the pads until water runs off instead of soaking in, which cuts the cooling. Scale also narrows the distribution lines and works the pump harder, while algae spreads across damp pads and through standing water in the tank. A badly scaled unit can end up needing pads, a pump and a valve at the same time.
Peak Air Conditioning Glen Waverley


Call or send a booking request between 6am and 10pm, seven days, describing the system, the rooms involved and the fault or job needed.

The technician inspects the house or the fault, checks sizing, access and wiring, then gives a written quote before any work or part is ordered.

Licensed technicians install or repair the system, test it in heating and cooling modes, explain the controls and leave the required compliance certificates.
Yes. An evaporative cooler runs on water, so scale, sludge and algae build up in the tank and on the pads every season it is used. A service cleans the tank, checks the pump, float valve and bleed valve, and confirms the pads are still wetting evenly. Without it, cooling drops and small faults such as a sticking float valve can turn into leaks.
Melbourne cost guides list the evaporative service as a pre-summer job, which suits a booking once a year in spring (The Quote Yard, 2026). The owner manual for the model sets the manufacturer's recommended interval. Coolers that run heavily through summer or use hard water benefit most from a yearly check. Winterising in autumn is a separate, quicker job.
The Quote Yard puts a pre-summer evaporative service in Melbourne, including pad inspection and water system checks, at around $180 to $320 (September 2026). hipages lists a national range of around $250 to $350 depending on the size of the home. New pads and repairs are extra. Peak Air Conditioning Glen Waverley gives a written quote after inspection.
Pads typically need replacing every two to five seasons, depending on the water the cooler uses (The Quote Yard, 2026). Hard water leaves more mineral scale, so pads in those conditions reach the end of their life sooner. A pad that is crusted, sagging or not wetting evenly is due for replacement. The pre-season service checks their condition each year.
There is no single best brand for every home. Breezair, Braemar and Coolair are all residential brands of Seeley International, which describes itself as Australia's largest air conditioning manufacturer. The right cooler depends on the size of the home, the number of outlets, the roof and the availability of parts and servicing. A refrigerated reverse cycle air conditioning system is the alternative for homes that also want heating.
Whatsthedamage.com.au puts a whole-house ducted evaporative system in Melbourne at around $2,950 to $7,350 supplied and installed, with $4,725 as a typical figure (November 2026). Replacing an existing cooler can reuse ducts that are still in good condition. The size of the home, the number of outlets and the roof access set the final price. Peak Air Conditioning Glen Waverley provides a written quote after an on-site inspection.
GET A FREE QUOTE
BUSINESS
SERVICES
OPERATING HOURS
Sun: 6:00am - 10:00pm
Mon: 6:00am - 10:00pm
Tue: 6:00am - 10:00pm
Wed: 6:00am - 10:00pm
Thu: 6:00am - 10:00pm
Fri: 6:00am - 10:00pm
Sat: 6:00am - 10:00pm